Viewing toolpath simulation for DentalCAM 6

In DentalCAM 6, there is not an integrated option for simulation or viewing of the toolpaths that are output. Sometimes it is necessary to verify that the correct sequence of operations has been output. You can do this by loading the individual .NC files into a free, online simulator located here: 

                                                    https://ncviewer.com/

The files necessary are located in the Output folder located here: C:\vhf\DentalCAM_6_17\CNCTransfer\Job0002\Output_W1 

Example shown below;


To load a file simply open the link to ncviewer.com and use the following icon to browse to, and then select the file you would like to simulate, these have a file extension of .NC 


You can then use the control ribbon at the bottom of the screen to simulate or change various settings.